Delta

Delta RMC200 Lite Motion Controllers

The RMC200 Lite Motion Controller offers 18 axes of control and supports up to 40 reference inputs. It has an integrated CPU and power supply module, with dedicated base modules, which provide a more compact footprint, lower power dissipation, and lower price point. All the I/O modules are interchangeable with the Standard RMC200, however, the power [...]

By |2021-03-31T16:57:34+00:00March 31st, 2021|Comments Off on Delta RMC200 Lite Motion Controllers

Delta RMC100 Motion Controllers

The RMC100 Motion Controllers share many hardware modules with the RMC150. The RMC100 CPU module uses older firmware and is programmed with Delta's RMCWin software. Although RMC100 Motion Controllers are fully supported and readily available, they are not recommended for new designs. They may make sense when duplicating an existing or in a retrofit/upgrade situation. [...]

By |2021-03-31T16:57:33+00:00March 31st, 2021|Comments Off on Delta RMC100 Motion Controllers

Delta RMC200 Standard Motion Controllers

The RMC200 Standard motion controller offers up to 50 axes of control and 104 reference inputs. It provides you with powerful motion commands and programming, with loop times down to 125μs. All the I/O modules are interchangeable between the RMC200 Standard and RMC200 Lite. The power supply modules and backplanes are not interchangeable. The RMC200 Standard uses [...]

By |2021-03-31T16:57:29+00:00March 31st, 2021|Comments Off on Delta RMC200 Standard Motion Controllers

Delta RMC70 Motion Controllers

The RMC70 is a modular controller. The base module is factory-configured and includes a CPU module and the Axis module. Each factory-installed Axis module is available with one or two control axis interfaces. You can add up to four expansion modules, including digital I/O, analog reference, and pressure or force inputs.

By |2021-03-31T16:27:56+00:00March 31st, 2021|Comments Off on Delta RMC70 Motion Controllers
Go to Top